Preserved bus:

Pegaso 5064 A/1

 Home

Back to index of buses preserved by ARCA

Back to index of preserved buses

Present owner:    A.R.C.A

 Original owner and fleet number:  Indústries Riva

Registration:  B-8268-CS

Year:  1978

Manufacturer:  Pegaso

 Model: 5064 Bodywork:  Beulas

Go to :

 
 Vic. January 1998.

Photo: Lluís Cuesta.

 

HISTORY

back to top
Start of service: 1978 (Indústria Riva)
Withdrawal: 2003 (Autos Casas)
This bus is a Pegaso 5064 with Beulas bodywork fit for interurban services. It is a classic interurban bus with capacity for 34 seated passengers. This bodywork was also mounted on vehicles working in the Mataró-Argentona route, Transports Gómez (Sarbus), and in the urban services from Mataró and Girona (Figueres). 

This vehicle started its career working for Industrias Riva taking workers to the factory. As time lapsed the bus would change ownership, the following list serving as record:

- Indústries Riva (workforce Transport)

- Companyia Pous 

- J. Argila (route Vic-Gurb)

- Bueno (route Vic-Tona) 

- Autos Casas (route Vic-Seva-Tona; Vic-Bartomeu del Grau) 

The last owner, Autos Casas, withdrew the bus during 2003 locking it up in a garage. It was discovered by ARCA in year 2006, being acquired and restored as a historic vehicle (more than 25 years old) with a livery close to the original one. This happened in 2007.

 

TECHNICAL SPECIFICATIONS

back to top
Motor  
Model 9130/17
Power  99 kW (135 cv) at 2600 rpm
Position Front, vertically placed
Cilinders 6 lined up
Diameter 107,25 mm
Stroke 120,65 mm
Cubic capacity 6550 cm3
Maximum couple 41,5 mkg at 1600 rpm
Feed Aspiration
Injection system Direct
Compression ratio 16:1
Clutch  
Type Monodisc
Diameter 353 mm
Drive Hydraulic
Gearbox
Type 6 relations manual
Rear shaft
Type Floating
Redution ratio 7,71:1
Steering
Type Servo Hydraulic
Brakes  
Type Air assisted of two independent circuits
Braking surface 3493 cm2
Parking brake MGM type combinated with emergency brake
Emergency brake Progressive action by coil
Fre motor -
Suspension  
Front Spring sheets, stabilizator and shock absorbers
Rear Spring sheets, shock absorbers and Torgo coils
Chassis  
Type Straight beams with constant width 
Width 875 mm
Cross section 216 x 65 x 8 mm
Electrical equipment  
Voltage 24 V
Alternator 840 W
Battery 4 of 6V and 126 Ah
Fuel tank  
Capacity 200 litres

Font: Catàleg Pegaso 1978

 

PHOTOS (Click on the photo to see it at 1024x768)

back to top

UAB Workshop - 02/06/2007. Photo: Josep Pretel

UAB Workshop - 02/06/2007. Photo: Josep Pretel

UAB Workshop - 01/06/2007. Photo: Josep Pretel

Workshop Autos Casas. Photo: Jaume Susany

Vic - 02/2003. Photo: David Arriola

UAB Workshop - 20/04/2006. Photo: Lluís Cuesta

UAB Workshop - 20/04/2006. Photo: Lluís Cuesta

Interior - 20/04/2006. Photo: Lluís Cuesta

Interior - 20/04/2006. Photo: Lluís Cuesta

Interior - 20/04/2006. Photo: Lluís Cuesta

Tablier - 20/04/2006. Photo: Lluís Cuesta

UAB Workshop - 20/04/2006. Photo: Lluís Cuesta

UAB Workshop - 20/04/2006. Photo: Lluís Cuesta

UAB Workshop - 20/04/2006. Photo: Lluís Cuesta

UAB Workshop - 20/04/2006. Photo: Lluís Cuesta

UAB Workshop - 20/04/2006. Photo: Lluís Cuesta

UAB Workshop - 20/04/2006. Photo: Lluís Cuesta

Vic - 02/09/1995. Time of Empresa Argila. Photo: Miquel Segura

Vic - 21/11/1992. Time of Empresa Argila. Photo: Francesc Xandri

TMB Horta Workshop - 29/05/07. Photo: Josep Pretel

 TMB Horta Workshop - 29/05/07. Photo: Josep Pretel

More photos on gallery about restoration works between februay 2006 and june 2007